Hi, I am using PE Micro Multilink LC Debug Probe when i connect the Multilink to Laptop the Driver its not showing in the Laptop - Device Manager. The Blue light is glowing in the device also when i connect the Debugger to the working board even Orange light is glowing.
But the device is not turned up which means
The message popping up says that
Erro in service launch sequence . The GDB server was not able to establish a connection to the target processor. Please check your connections and power. Verify that the launch setting in the Debug configuration are accurate. To run simultaneous debug sessions, please specify unique Server port and GDBMI Port in the Debug Configuration for Each Project.
So the above message is getting popped out
so whether the issue with the driver ?? or whether The device gets Bricked up or something. How to resolve this issue
when i connect Power supply LED is glowing but the device is not getting recognized. How to overcome this issue
Hi Tom,
You should update to the latest eclipse plugin. You didn't say what your target device was and what IDE you are using.
Here is a generic guide for eclipse:
https://www.pemicro.com/learningcenter/contents.cfm?content_id=73
Regards,
Hi,
So i am using the S32 Design Studio and S32G VNP RDB32 Board where SJA1110 Board which i need to flash
so i heldp up with the issue when i connect the PE Micro Multilink to the laptop blue color light is glowing but when i am trying to debug the configuration its stating up the issue which i mentioned
i even tried changing the USB to Printer cable but the still issue is persisting
I even able to see the orange light after connecting to the board
I am not sure where the issue is coming so whether above solution will resolve my problem or should i need to try out different Method to overcome this issue
Is there any issue with the Driver Package ??
I even Tried checking the debugger there is no connection termination or solder out thing is not there suspecting some driver problem
So can you give me the brief solution to overcome this issue which might be helpful for me
i was working on this Debugger before this issue it was working fine without any issue but all of a sudden when i try to run via Debug_RAM its not running i am not sure why this happened because few hours before this issue the debugger was working fine
can you give me a suggestion what might be the root cause?
Regards
Tom,
Tom,
>i even tried changing the USB to Printer cable but the still issue is persisting
I'm not sure what you did here. Are you talking about USB to LPT port? We don't support LPT ports.
What I would do is create a brand new blinky project with the NXP SDK builder for your evaluation board and create a new debug configuration. Do a test in the new project. This will tell us if there is something misconfigured in your project.
Regards,
Johnny
Hi, I meant changed the cable which is connecting between laptop and debugger which will be connected via USB to printer cable.
I even tried testing this 3 different laptop setups which gives same issue as the result
What are the other setup to find this issue
Whether need to upgrade some drivers ?
Add on to that i even checked in device manger where we will be finding what are the Ports getting connected but there also its not even showing PE micro device which will be connected
There is no such device is connected
Hi,
You can try reinstalling the drivers from this link.
https://www.pemicro.com/downloads/download_file.cfm?download_id=346
If you are seeing the same issue on three different PCs, then it sounds like there is a hardware issue with the Multilink especially if this was working perfectly fine recently.
Would you like to ship it back to us for inspection?
Your other option is just to trade it in for a new one.
https://www.pemicro.com/products/product_viewDetails.cfm?product_id=15320176
Regards,
Johnny
PEmicro