Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
Programming issue
Adam Z. Feb 19, 2020 at 04:36 AM (04:36 hours)
Staff: Johnny N.

  • Our customer bought 3pcs S912ZVLA64F0MFM, used it several times, and now all have the same failure.
    Burning chip: S912ZVLA64F0MFM
    Operating system: Windows 10

    P&E Connection Assitant:
    An error occured while connecting to the interface hardware or target specified in the launch Configuration Dialog. For this launch, you may retry/re-specify the connection with the following parameters.

    Would you please check the issue, I can't upload the screen shot.




    Comments

    • Hi Adam,

      Which PEMicro interface and also software are you using?

      Is their board a new prototype or have they programmed it with PEmicro tools in the past?

      Regards,
      Johnny
      PEmicro

  • The customer is using the CodeWarrior programming software and the board for debugging the NXP S12 MCU (the chip on the board is S912ZVLA64F0MFM), so use this "U-MULTILINK-FX" (RS 752-2386) programmer, which can be used several times. I found it unusable later. If it is difficult for the supplier to judge, can I send them for judgment or repair?

    • Hi Adam,

      Yes you can send it back to us for analysis. If it is damaged, we will repair or replace it. However there might be a cost if the unit is not under warranty.

      When was the device purchased? Are you located in the US or international?

      Regards,
      Johnny
      PEmicro

Add comment


   Want to comment? Please login or create a new PEmicro account.







© 2021 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement