PEmicro logo
Cart New Account Login

Logo image
HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
Multilink connection error with S32K148 MCU
R D. Jan 21, 2020 at 01:18 PM (13:18 hours)
Staff: Mika I.

  • I'm trying to debugging a S32K148 target board with SWD pins. The board was created following the hardware design guide from NXP. It only consists of essential cap, xtal and resistor for a simple MCU bring up purpose. I use S32 Design Studio for ARM for debugging. But it gives me a connection error. I scoped the signal lines and find that the Reset stays low, even thought I have a 10k pull-up on that line. I'm wondering if there's a special procedure for a micro that has never been programmed before.


  • Hi,

    Please follow these instructions for installing/updating the PEmicro plug-in
    for S32DS:

    Hopefully our latest plug-in will resolve your connection issue.


  • Hi,

    Just checking in. Did the latest plug-in resolve your issue?


Add comment

   Want to comment? Please login or create a new PEmicro account.

© 2021 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement