Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
repetitive reset output failure
Daniel K. Feb 2, 2018 at 04:30 AM (04:30 hours)
Staff: Johnny N.

  • below is my test procedure

    1. Did binary writing with load SAP file by CYCLONE PRO(= downloader tool)
    SAP file for NO.1
    SAP --> CM (=S12ZVL32) --> SS (=S12ZVL32.S19)--> EM --> PM --> VM

    2. Operating test result is good on application board.(power output, reset output & etc. )

    3. Again binary writing with load SAP file by CYCLONE PRO(= downloader tool)
    SAP file for NO.2
    SAP --> CM (=S12ZVL32) --> SS (=S12ZVL32.S19) --> PM

    4. Operating test result is repetitive reset output happen.

    Question
    --> Therefore would you pls let me know the suspected root cause ?




    Comments

  • Hi Daniel,

    Are you programming the same board in step 1 and step 2? In step 2 you don't erase the board first before programming. If this board was already programmed in step 1, then this will likely result in verification errors.

    Regards,
    Johnny

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2019 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement