Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
MPC5748G Cyclone Max Error $000A
Richard B. Jun 2, 2016 at 03:15 PM (15:15 hours)
Staff: Takao Y.

  • I am getting the following error while trying to program a MPC5748G using the Cyclone Max.

    $000A: Error writing a block of data to target

    I need help understanding what could be failing? Is this a Cyclone Max setup problem? I am using the following programming sequence.

    CM C:\PEMicro\FlashAlgorithms_Internal_NXP_QORIVVAP\Freescale_MPC5748G_1x32x1524k_CFlash.pcp
    SS C:\Projects\bin\outputs\GwApp-
    EN ;Erase if not Blank
    PM ;Program Module
    VC ;Verify Checksum

    Note: I use a similar sequence with the MPC5746C (which is a similar micro to the MPC5748G) and I am able to program with no problems.


  • Greetings,

    Try lowering the debug shift speed within the image creation utility. You are probably talking to the chip too fast. Your setup looks fine otherwise. Another thing to try is adding a 200ms delay after reset.

    Takao Yamada

  • Greetings,

    Any update on this? Were you able to connect to your target?

    Takao Yamada

Add comment

   Want to comment? Please login or create a new PEMicro account.

© 2018 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement