Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

Please accept the use of cookies on our site

At PEmicro we use web browser cookies in order to provide you with an enhanced experience and in order to be able to do things like shopping cart processing and identify you when you login to our website.

Click here to accept

search inside this forum
search inside all forums
message of PROGS12Z_CYCLONE PRO Programmer
Ikki S. Nov 24, 2014 at 05:12 AM (05:12 hours)
Staff: Takao Y.

  • Dear person in charge,

    The following message is shown during the ROM image programming
    and it seems to be wrong.
    Checking range of S records. Invalid address detected.
    Invalid addresses in srecord block from $00001400 to $0000141F.
    I referred the datasheet of target device, but the area is for Flash(it says "Unpaged P-Flash Page 0x0C"), just normal.

    Could you give me your advice where we should check?

    [Programming Environment]
    SW P&E programmer : PROGS12Z_CYCLONE PRO Programmer version
    HW P&E product : CYCLONE PRO
    Argorism File : Freescale_MM912J637_1x16x64k_128k_Linear_Pflash.12P
    Target device : Freescale MM912J637

    Best Regards,
    Ikki Shingu


  • Greetings,

    You are using the wrong software. You need to be using PROG12Z, not PROGS12ZZ. It is also included in your Cyclone Pro software package. Yes, it is confusing but Freescale named these chip families so similar that it is hard to distinguish the difference.

    Also, you must use physical addressing instead of logical addressing in our software and hardware tools. Use the LOG2PHY utility to convert your S19 file into a PHY file. Make sure to select the correct chip in the utility to make the correct conversion:

    Takao Yamada

Add comment

   Want to comment? Please login or create a new PEMicro account.

© 2018 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement