Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service


Please accept the use of cookies on our site

At PEmicro we use web browser cookies in order to provide you with an enhanced experience and in order to be able to do things like shopping cart processing and identify you when you login to our website.

Click here to accept



search inside this forum
search inside all forums
Error loading algorithm file
liu j. migrated on Dec 31, 2013 at 11:00 AM
No staff assigned yet

  • Hi All,

    I'm a beginner for Freescale HCS08 processor development and meeting a flash programming problem as below. Can you provide some instruction and information. Appreciated in advance.

    information:
    Initializing .(Recommended Trim = $00) (Bus Freq = 3570KHz) Initialized.
    ;version 1.04, 07/10/2009, copyright P&E Microcomputer System, www.pemicro.com [9S08AW16]
    ;device Freescale, 9S08AW16, All
    ;begin_csError loading .S8P file:c:\pemicro\cyclone_pro\algorithms\HCS08\9S08aw16.S8P at address 00000070

    Error loading .S8P file : c:\pemicro\cyclone_pro\algorithms\HCS08\9S08aw16.S8P at address 00000070





    Comments

  • QUOTE (jack @ Aug 3 2010, 10:00 AM) [legacy comment]
    Hi All,

    I'm a beginner for Freescale HCS08 processor development and meeting a flash programming problem as below. Can you provide some instruction and information. Appreciated in advance.

    information:
    Initializing .(Recommended Trim = $00) (Bus Freq = 3570KHz) Initialized.
    ;version 1.04, 07/10/2009, copyright P&E Microcomputer System, www.pemicro.com [9S08AW16]
    ;device Freescale, 9S08AW16, All
    ;begin_csError loading .S8P file:c:\pemicro\cyclone_pro\algorithms\HCS08\9S08aw16.S8P at address 00000070

    Error loading .S8P file : c:\pemicro\cyclone_pro\algorithms\HCS08\9S08aw16.S8P at address 00000070


    Hello Jack,

    This error messages means that the software was unable to load the flash programming code into the sram of the microcontroller. This indicates some type of communication problem.

    What P&E hardware interface are you using to communicate with your board? Is it a cyclone pro?

    How are you providing power to your board?

    Please recheck your pcb traces to ensure that the RESET, BKGD, GND, and VDD pins on the microcontroller are
    connected to the correct pins on the BDM header.

    We recommend you put a 4.7kohm - 10kohm pullup resistor on RESET and BKGD.

    Are you using some type of custom connectors or ribbon cables?

    Best Regards,
    Johnny
    P&E Technical Support

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2018 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement