http://www.pemicro.com/forums/index.php Wed, 16 May 2012 23:53:28 -0400 10 http://www.pemicro.com/forums/index.php?showtopic=5663 Wed, 16 May 2012 16:16:42 -0400 http://www.pemicro.com/forums/index.php?showtopic=5663 http://www.pemicro.com/forums/index.php?showtopic=5662 Wed, 16 May 2012 16:13:22 -0400 http://www.pemicro.com/forums/index.php?showtopic=5662 http://www.pemicro.com/forums/index.php?showtopic=5553 ]]> Wed, 09 Nov 2011 03:52:02 -0500 http://www.pemicro.com/forums/index.php?showtopic=5553 http://www.pemicro.com/forums/index.php?showtopic=5654
My host PC is Windows 7 - 64 bit and I'm setting up a Windows XP VM. I set up the VM to pass through the USB device, but each time I connect the USB my host picks it up and installs drivers for it immediately (even after uninstalling all drivers on host). The guest/virtualbox can no longer grab the device because I assume the host has control. I have the drivers set up on my guest ready to go but I just can't figure out how to pass this device. I am able to pass my CodeWarrior licensing dongle with no problems (and have passed many other USB devices no problem as well).

I've also heard that you can get this to work on Windows 7 - "XP Mode". I've only briefly looked at this option (would really like to get it to work on VirtualBox) and was not having any success with it either with the same problem of passing this USB device.

Figure it's a shot in the dark, but does anyone have any experience with this?]]> Mon, 16 Apr 2012 16:36:54 -0400 http://www.pemicro.com/forums/index.php?showtopic=5654 http://www.pemicro.com/forums/index.php?showtopic=5652
We've just bought an new Universal Multilink FX but we can't program anything with it. We've tried with an S08DZ60, S08DZ128 or even a Kinetis K60.
We're using the last release of IAR IDE EWARM S08.
We're connected to an EVB9S08DZ60 that can be programmed fine with an old USB Multilink. But, with the FX, we've the following log :

Thu Apr 12 15:53:23 2012: Loaded macro file: C:\Program Files\IAR Systems\Embedded Workbench 5.4 Kickstart\s08\config\flashloader\mc9s08dz60.mac
Thu Apr 12 15:53:25 2012: P&E Interface: Unable to open selected port.
Check power supply and cables.

Press YES to try again with this port.
Press NO to exit debugger.
Thu Apr 12 15:53:41 2012: Failed to load flash loader: C:\Program Files\IAR Systems\Embedded Workbench 5.4 Kickstart\s08\config\flashloader\FlashFragmentStyle_4K.d78
Thu Apr 12 15:53:41 2012: Failed to load flash loader: C:\Program Files\IAR Systems\Embedded Workbench 5.4 Kickstart\s08\config\flashloader\mc9s08dz60.flash

Our driver are OK in the Device Manager : Jungo > USB Multilink 2.0 and WinDriver

So, what could we do to make it works please ?

Thank you.

Regards]]> Thu, 12 Apr 2012 10:03:59 -0400 http://www.pemicro.com/forums/index.php?showtopic=5652