Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
Use codewarrior and PEMICRO to burn program for S08DZ60
sinber z. Sep 15, 2020 at 02:35 AM (02:35 hours)
Staff: Takao Y.

  • Hi, I am using codewarrior V6.3 on a 32-bit windows 7 computer to program the S08DZ60 chip. The blue PEMICRO Multilink Universal is used, the version is Rev.D. But the following error occurs:
    Loading Target ...
    Windows NT detected.
    P&E Interface detected-Flash Version 1..4
    Frequency change to ~178321hz.
    Device is 9S08DZ60.
    Mode is In-Circuit Debug.
    IO registers loaded for MC9S08DZ60 from C:\Program Files\Freescale\CodeWarrior for Microcontrollers V6.3\prog\REG\MCU1027.REG
    executing BDM_P&E_Multilink_CyclonePro.hwc

    done BDM_P&E_Multilink_CyclonePro.hwc

    Error: The debugger is currently not able to run
    due to loss of contact with hardware.
    No Link To Target
    ——————————————————————————————————
    But in another green version of the writer named Rev.C, it can burn successfully. The information is as follows:
    Loading Target ...
    Windows NT detected.
    P&E Interface detected-Flash Version 6.15
    Frequency change to ~15805785hz.
    Frequency change to ~18042452hz.
    Frequency change to ~8874709hz.
    Device is 9S08DZ60.
    Mode is In-Circuit Debug.
    IO registers loaded for MC9S08DZ60 from C:\Program Files\Freescale\CodeWarrior for Microcontrollers V6.3\prog\REG\MCU1027.REG
    Startup command file does not exist.
    executing BDM_P&E_Multilink_CyclonePro.hwc

    done BDM_P&E_Multilink_CyclonePro.hwc

    Preload command file does not exist.
    Frequency change to ~7968750hz.
    executing C:\Users\Administrator\Desktop\Project\bin\Project.xpr

    !Data:1 <ADDXPR ONLY_ADD_IF_NEW "AD_Trans_Value"
    Target Ready
    done C:\Users\Administrator\Desktop\Project\bin\Project.xpr

    executing C:\Users\Administrator\Desktop\Project\bin\Project.xpr

    !Data:1 <ADDXPR ONLY_ADD_IF_NEW "AD_Trans_Value"
    MCU Device Selection has been changed.
    done C:\Users\Administrator\Desktop\Project\bin\Project.xpr

    Postload command file does not exist.
    Frequency change to ~17957746hz.
    STARTED
    RUNNING
    ——————————————————————————————————
    What may cause the Rev.D programmer to not work normally? It may be
    Is the reason for "P&E Interface detected-Flash Version 6.15"




    Comments

  • Greetings,

    We have a few other customers seeing this and I may have a workaround for you. But to send you files you need to create a support request ticket on our support page.


    Takao

Add comment


   Want to comment? Please login or create a new PEmicro account.







© 2021 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement