Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
Can't connect to SPC5602D
Toni S. May 15, 2020 at 04:54 PM (16:54 hours)
Staff: Takao Y.

  • Hello,
    I have a USB Multilink universal FX and the starter version of PPCNexus. I'm trying to get access to a SPC5602D Microcontroller. I didn't program that device and I'm not sure if this is censored.
    When I connect it I get back this message in the connection Window:
    can't communicate with the target processor....
    i get an IDCODE :00000244 and id revision $00000001
    it shows: debugger retrying to force to background mode. is this the point were it gets stuck when the wrong censorship password is entered?

    toni




    Comments

  • Greetings,

    Yes, if the ID code is detected but you cannot enter debug, then it means the chip is probably censored and you cannot go forward.


    Takao

  • is it possible to find out the censorship password?

  • Greetings,

    If you find the original binary file that was used to program the device, then yes. Otherwise, no because that would completely defeat the purpose of censoring the device.


    Takao

Add comment


   Want to comment? Please login or create a new PEmicro account.







© 2021 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement