Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
Port: LPT1: Parallel port 1 (Not Detected)
Ayan B. Aug 12, 2019 at 02:57 AM (02:57 hours)
Staff: Takao Y.

  • We are using PEMicro multilink_universal stand alone programmer to program target micro controller. But when we connect PEmicro hardware set up and try to start programming through PROGPPCNEXUS apllication tool, in GUI it is showing as scanning and tool is automatically closing without any log. 

    Please let us know what may be the cause for this issue? Any issue related to driver installation or any other error causing this?




    Comments

  • Greetings,

    Sounds like you are actually using CPROG ppcnexus instead of PROG ppcnexus. Change up the software and you will have a better experience.


    Takao Yamada

    • We are using Progppcnexus programmer- Version 6.22.00.00 not the CPROG ppcnexus and hardware used is USB Multilink 2.0.

      We were able to program through this earlier days. Few days back we changed the PC and installed the software tool again. After that we are not able to program and facing the issue which is mentioned in the earlier comment.

      Also we found one more error in device properties as;
      "Device USB\VID_1357&PID_0503\PEME5FB1E requires further installation."

      Also in Timestamp Events in description it is showing as "Device install required"

      Please let us know what exactly this errors indicates?
      Is there any driver installation error? Do we need to install the driver again? If so please share the driver which is suitable for the above mentioned tool.

      Also please provide us the proper installation steps for PE Micro multilink tool.

      Regards,
      Karthika B S

  • Greetings,

    Drivers:
    http://www.pemicro.com/downloads/download_file.cfm?download_id=53

    Install drivers without multilink connected to computer. After install, attach your multilink to your computer and make sure device manager does not complain.

    Then in PROG software you should see your multilink show up properly. The software should never crash on you like that, which is why I thought maybe you were using CPROG.


    Takao Yamada

  • Also, make sure you are selecting USB Interface, not parallel interface.

  • Greetings,

    Any update on this?


    Takao Yamada

Add comment


   Want to comment? Please login or create a new PEmicro account.







© 2019 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement