Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
Exclamation marks in Device manager, Failure message in CodeWarrior
Laszlo T. Jul 31, 2019 at 03:01 AM (03:01 hours)
Staff: Johnny N.

  • Hi !
    I connected an S9S12GA128 uC to the Multilink Universal FX debugger and installed a CodeWarrior CWS12v5.2 on my W10 in order to flash it. The PC has not recognized the debugger appropriate because in the device manager can any exclamation marks be seen. I did any times driver update but the situation is the same.
    In CodeWarrior after loading Projekt File and putting 'Debug' button there is the next message coming:
    'The debugger can not connect to the P&E BDC interface or targeted hardware board.'

    What would you recommend to do please ?

    Thanks.
    László




    Comments

  • Hi Laszlo,

    Can you tell me exactly what you see under Device Manager -> Jungo?

    Please also run our driver test and post the result.
    http://www.pemicro.com/downloads/download_file.cfm?download_id=152

    Regards,
    Johnny

  • Hi Johnny,

    here the result of the driver test:
    'No errors were detected.

    Download the latest PEMicro drivers from:
    http://www.pemicro.com/downloads/download_file.cfm?download_id=53.
    If the problems detecting your PEMicro interface persist, please contact
    PEmicro Support team and provide your complete software and hardware setup.'

    I think, my problem is already solved.
    I got from NXP the suggestion, I should do a firmware update according to the link 'http://www.pemicro.com/downloads/download_file.cfm?download_id=346'.
    I did the updating and no exclamation marks appeared at some new devices under Jungo.
    Afterwards I could do the flashing of the uC.

    I can see under Jungo the following devices without exclamation marks now:
    pemicrowindrvr;
    USB Multilink 2.0

    and with an exclamation mark:
    WinDriver

    Regards
    Laszlo

    • Hi Laszlo,

      You can uninstall and delete WinDriver. You don't need that for Windows 10.

      Let me know if you have any other questions.

      Regards,
      Johnny
      PEMicro

Add comment


   Want to comment? Please login or create a new PEmicro account.







© 2019 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement