Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
controller fail to run after programming
VINOD D. May 16, 2018 at 01:24 AM (01:24 hours)
Staff: Takao Y.

  • hey i am using cyclone-fx for copying code on coldfire controller (MCF52258CAG66 and MCF51QE128). These controller are place on single board. I have copied code from another controller on .S19 formet. When i copy the code on MCF52258CAG66, the display of my controller card is running but my card is not interfere between output and input. what can i do help me!




    Comments

  • Greetings,

    Did you make sure to copy the entire flash of both devices? Make sure to call the verify module command after programming.

    If the programming is successful and yet you still have issues, then you are going to have to start debugging your project. There is nothing else the cyclone can help your project. Its only function is to flash program your S19 file.


    Takao Yamada

Add comment


   Want to comment? Please login or create a new PEmicro account.







© 2020 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement