Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Releasing Reset after programming with 9S12 target
Jackson J. Nov 23, 2017 at 08:10 PM (20:10 hours)
No staff assigned yet

  • I am using a Cyclone Pro to program and verify a 9S12E64 in a production jig.
    The Cyclone Pro is run in stand-alone mode.

    The program/verify succeeds, but the Cyclone then holds the reset line low.

    I can power cycle the target, but the target cannot run because the reset is held low so I cannot run my production tests.

    The order of operations I am using is:
    CM
    SS
    EN
    BM
    PM
    VM
    VC

    Is there a way to configure the cyclone image to release reset?




    Comments

  • I've resolved this issue.
    The Cyclone Pro had the links on the side set for "Cyclone Pro Internal Power" but I was not using power from the Cyclone Pro.

    With the links removed, the reset line is behaving correctly.

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement