Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Installation PSA with W7
Marie Rose C. Jul 26, 2017 at 05:01 AM (05:01 hours)
Staff: Johnny N.

  • I have a PSA rev C. used . All is OK with XP. Now, I try to install it in a PC with W7 (64bits) but I have a problem. During the installation, this message appears : Cannot run an x86 build of this utility on x64 platform". I have installed the new driver but without success.

    Coul you help me ?




    Comments

  • HI What software are you trying to install?

  • Thank you for your reply.

    I'm trying to install the firmware update from the website : Cyclone Pro Single File Installation and the new drivers : P&E Hardware Interface Drivers, Version12.
    Now, I don't have the last error message. At the end of storing image to the cyclone pro, I have the message "success (Image CRC32=$BD75857)" but on the cyclone pro is not ok : "transferring Images" always.

    Could you help me ?

    • Could you help me ? It's very URGENT

      • Are you using the Image Manager to transfer the image?

        Does it work if you transfer it directly using the Cyclone Image Creation Utility?

        Please tell me step by step in detail what you are doing. I will be able to help you after I get a better idea of the procedure you're following.

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement