Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
DOS Error 72
Kaustubh K. May 31, 2017 at 06:44 AM (06:44 hours)
Staff: Kevin M.

  • Hello,

    We are programming STM32F405ZG controller with the help of Cyclone FX programmer.

    Few of our controllers are not getting programmed and DOS error 72 is displayed on the screen (We are programming with the help of cprogacmp.exe). Such an event occurred in 27 controllers out of 100 controllers we programmed. Rest all 73 controllers are programmed and verified from our side.

    Help me in resolving the same. Thanks in Advance!

    Please provide me your technical team member's email id so that we can send him the screen shot.

    :DEVICE ST_STM32F4_STM32F405ZG
    :useswd 1
    :DEVICEPOWER 2         \\3V POWER TO DEICE TARGET
    :PROVIDEPOWER 1         \\ENABLE POWER TO TARGET
    :POWERUPDELAY 100      \\POWER UP DELAY 100 milli seconds
    :POWERDOWNDELAY 500      \\POWER OFF DELAY 500 mseconds
    :POWEROFFONEXIT 0
    RE            ;Reset
    CM C:\PEMicro\PROGACMP\supportFiles_ARM\ST\STM32F4\ST_STM32F405ZG_1x32x256k.arp
    ;Choose Algo
    UP            ;Read/Write Unprotect
    EM            ;Erase Module
    BM            ;Blank Check Module
    SS \\.s19 path       ;Program Path
    PM            ;Program Module
    VM            ;Verify Module
    VC




    Comments

  • Kaustbubh,

    We have updated the F4 algorithms recently.

    Has the issue been resolved?

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement