Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
search inside all forums
Program Bytes function issue for S912ZVC96M chip by P&E Micro Pro Tooling.
yong w. Mar 15, 2017 at 09:37 AM (09:37 hours)
Staff: Juan S.

  • Hi Sir:
    we want to use program byte function of micro pro tooling to write serial number and ID into start address for s912zvc96m component. But we only can write 00 and cannot write other mumber.below is our requirement of write:

    Serial number written: Start address: 0x1007D8 . Length: 20 byte. Format: ASCII

    Value: 00000000000000000001, 00000000000000000002…. And so on.

    Hardware ID written: Start address: Followed by Serial number. Length : 12 bytes. Format: ASCII. Value: C894000001J(the last value is a space in ASCII and don't display here)
    DATA Matrix code: it contains the same content as the serial mumber.

    so, could you please help to give some supports for use PB function to write above value into component?
    By the way, we also want to use serialize setup program to create serial file then load to auto write, but this programming only support length 16 byters, we need 20bytes + 12 this method failed.

    Thanks very much! And best regards!


  • Greetings,

    We do not support custom sized serial numbers. You are best off to use the cyclone control suite to allow you to write dynamic data.

    Takao Yamada

Add comment

   Want to comment? Please login or create a new PEmicro account.

© 2019 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement