Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
PROGHCS08 Programmer - Settings
Meghana S. Oct 16, 2015 at 11:33 AM (11:33 hours)
Staff: Takao Y.

  • Hello

    We are trying to program a S9S08RN32 micro using the PROGHCS08 Programmer. We would like to know the various setting fo rthe Connection Manager. At the mormrnt, we are getting the following error.

    "The target MCU is not responding. Please turn MCU power off (Under 0.1v), turn MCU power on, and then click OK. This will attempt to enter debug mode through a power on reset sequence."

    Our current settings are as follows:

    Interface: USB Multilink, USB Multilink FX, or Embedded OSBDM

    Port: USB1: Multilink Universal FX Rev B (PEM7B5CEB)

    CPU: HCS08 Processor - Autodetect

    Reset Options: Check box not selected for "Delay after Rest and before communicating to target for --- milliseconds".

    Provide power to target : Checkbox selected
    Power Down Delay: 250 mS
    Power Up Delay: 1000 mS

    Thank you.
    Meghana




    Comments

  • Greetings,

    1) You want to check the reset delay if your board has a reset circuitry. If you know it does not, then you can uncheck this. But if you are not sure, you should try adding a 200ms delay to see if it improves communication.

    2) For the RN32, what components do you have connected on:
    a) VDD,
    b) RESET, and
    c) BKGD?

    3) Are you using any adapters, custom ribbon cables, or other unique hardware that you should tell me?


    Takao Yamada

  • Greetings,

    Any update on this? Please answer the questions I have previously posted.


    Takao Yamada

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement