Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Is there any utility that uses the P&E USB multilink interface to read and save the machine codes or assemble codes from an un-protected or un-secured flash MCU (HCS12 series)?
344275774@qq.com X. May 12, 2015 at 01:05 AM (01:05 hours)
Staff: Takao Y.

  • Hello, I want to get the machine codes or assemble codes from a HCS12 target board. The HCS12 MCU chip is un-protected and un-secured. Is there any utility that uses the P&E USB multilink interface to  read and save the machine codes or assemble codes from an un-protected or un-secured flash MCU (HCS12 series)?




    Comments

  • Greetings,

    You should purchase the PROG12Z software:
    http://www.pemicro.com/products/product_viewDetails.cfm?product_id=49

    In there is a command called Upload Module (UM). Use this to dump the memory contents into S19 format. Then you can use that later to program another chip.


    Takao Yamada

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement