PEmicro | Experts in Embedded tools for Flash Programming and Development

Wednesday, February 11, 2015

PROGPPCNEXUS DEMO software create error meassage - out of range
Nai Pin K. Feb 11, 2015 at 09:37 PM (21:37 hours)
Staff: Takao Y.

2 comments

I am using PROGPPCNECUS demo software to try out my programming on MPC5775K ..
I do an "Upload Module", save the file as A.S19. Then I load this file into the "Specity Object File". When I do a "Verify Module" or "Program Module", there is this error message appear,

Checking range of S records. Checked
Verifying address $  Error- out of range
Error while loading S record file.

why there is this error? I am not able to do program or verify module.
Hope to hear from you as soon as possible.

Comment #1 Nai Pin K. - February 11, 2015 - 09:37 PM (21:37 hours)

Comments

Greetings,

This is because you have the demo software. The demo is code-size limited to 
64K of data. Your file is over that limit so the software gave you the "out of 
range" error. If you purchase a full version of the software, then you will not get this error message. You could also be getting this error message if your S19/ELF file is outside of the algorithm's specified address range. Make sure you have the correct algorithm.


Takao Yamada

Comment #2 Takao Y. (PEMicro Staff) - February 12, 2015 - 10:55 AM (10:55 hours)

Add comment

Want to comment? Please login or create a new PEMicro account.