Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Multilink Universal Debugger
Punit K. Nov 21, 2015 at 03:17 AM (03:17 hours)
Staff: Takao Y.

  • Hi
    I have a Multilink Universal which is printed "Freescale Enabled" on its bottom sticker.
    But i found on P&E site that Multilink support other MCUs as well like STM or ATMEL.
    So my question is, how to use it to debug ST MCUs (or others mentioned in the list)? Is there needed some spacial hardware or software?
    And what is the mean of 'Freescale Enabled'?

    Regards
    Punit Kumar




    Comments

  • Greetings,

    Which revision of the multilink universal do you have? You need revision C to be able to support other ARM devices from other vendors like STM or ATMEL.
    There is nothing special you need to do to support it, as long as you have revision C.


    Takao Yamada

    • Thanks for the response.
      And what if i have Multilink Universal Rev. B?


      Punit Kumar

  • If you have Multilink Universal FX, then you need revision B to support the other ARM vendors.

    • Does that means my Multilink Universal (not FX) only supports Freescale MCUs?

      Punit Kumar

  • Greetings,

    This means multilink universal rev A and rev B ONLY supports Freescale chips.


    Takao Yamada

    • Thank you for the information.

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement