Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Error $00000007 occur when program using Cyclone MAX
Ran S. Oct 11, 2017 at 05:26 AM (05:26 hours)
Staff: Kevin M.

  • The MCU I use is K22FN512.
    The Cyclone Max v7.93-6.2

    I have used Cyclone MAX device to program before. This is a new device. After load the SAP image into Cyclone, every time pressing "Start" it directly jump to error and show the code $00000007.
    I have tried PROG, lower the shift frequency to 2MHz, program it step by step, and nothing fault happen. Everything seems OK. But the SAP programming still fail due to $00000007.
    I may need some assistance on this.
    Thanks.




    Comments

  • Ran,

    Are you using SWD or JTAG?

    If you are using SWD you need an adapter

    • I am actually using JTAG...

  • Ran,

    Is your target powered? Do you have the latest cyclone max firmware installed?

    Best,

    Kevin

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement