Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
CYCLONE RENESAS ERROR CODE $00000007
Reiz Troy D. Jan 10, 2017 at 02:01 AM (02:01 hours)
Staff: Esteban G.

  • Hi,
    I was just assigned to automate the process of flashing F562T6EDFM and 62TAE using PE Micro (CYCLONE for RENESAS). I almost read all of the guides but I keep on having the ERROR CODE $00000007 (Error entering debug mode). Can you please help to verify my setup and give the possible causes of the error (and solution also).

    Setup details:

    PIN CONFIG
       CYCLONE RENESAS      TARGET (F562T6EDFM)
       1   NC   ->   -
       2   GND   ->   8
       3   NC   ->   -
       4   EMLE   ->   10 EMLE
       5   TXD   ->   7 TD OUT
       6   MDE   ->   -
       7   MD1   ->   3 MD1
       8   VDD   ->   6 3V3
       9   NC   ->   -
       10   MD0   ->   1 MDO
       11   P66(RXD)->   5 TD IN
       12   GND   ->   8
       13   RESET   ->   4 RESET
       14   GND   ->   8

    Algorithm: RX_R5F562T6.RXP
    Im using a .MOT srecord file for the object code


    Best Regards,
    RTDurante




    Comments

    • Correction: I got the error $0007 (Error enabling module) from SAP_LAUNCH.

  • Hi Mr. Esteban G., may I ask your advice please. It's been more than a week.
    Please help.
    I got a new error of $00003003 (Program operation failed or was cancelled).
    My algorithm is RX_R5F562T6.RXP.

  • Hi ,

    Please refer to our open support request on this issue.

    Best regards,
    Esteban

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement