Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Stand-Alone Programming of SPC58NE84
Whitney C. Mar 21, 2016 at 04:58 PM (16:58 hours)
Staff: Takao Y.

  • Hello,

    I am trying to program the SPC58NE84 using an image file stored on the Cyclone Max and am getting error $00000007. Here is the sequence that I am using:
    1. Choose algorithm: ST_SPC58NE84_1x32x5236k.CFlash.pcp
    2. Specify object code
    3. Erase if not blank
    4. Program module
    5. Verify checksum

    Debug shift speed is set to 3.85MHz.

    I am able to program using the PROGPPCNEXUS programmer using the same debug shift speed setting and steps. We are using a 1-1 wire harness to go from test points on the PCB to the Cyclone Max programmer. Any suggestions as to what we are doing wrong trying to use the Cyclone Max as a stand-alone programmer?

    Thank you,
    Whitney




    Comments

  • Target architecture is set to the Qorivva.

  • Greetings,

    Have you tried downloading the latest Cyclone Max software package? We have supported standalone programming for the SPC58NE84 for some time now. Here is the software link:
    http://www.pemicro.com/products/product_viewDetails.cfm?product_id=145


    Takao Yamada

  • That worked. Sorry, I didn't consider that since using the PROG tool was working. Thank you!

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement