Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Issues in Partitioning of K10 using Cyclone
gautam j. May 15, 2015 at 09:21 AM (09:21 hours)
Staff: Johnny N.

  • Hello Team,

    I am using Cyclone Max to partition the chip memory of Freescale K10 (MK10DX256VLQ10). But I am not able to do this. Can you support?

    I am executing following steps to do this.
    CM C:\PEMicro\cyclone_max\Algorithms_Kinetis\freescale_kdx_pflash_dflash_eeprom.arp
    SS; Select my FW build file
    RE; Reset
    PA 3206; Partition
    EM; erase module
    BM; blank check module
    PM; program module
    RE; reset
    GO; go

    I want to partition memory as
    4KB - EEPROM; Subsytem A = 2KB, Subsystem b = 2KB
    0kb - dFlash

    Regards
    Gautam




    Comments

  • Hi Johnny,

    I am doing this as suggested in that link.

    In this case,
    EESPLIT = 2 or 3
    EEESIZE = 2
    DEPART = 6 or 8

    So, argument for PA (partition) command can anyone of the following
    0x2208
    0x2206
    0x3208
    0x3206

    I tried all this combinations. But no success yet.
    The loaded FW does not seem to work.

    Regards
    Gautam

  • Can you please look into this?
    Its very urgent on my side.

    Regards
    Gautam

    • Gautam,

      I am still looking in the issue. Sorry about the delay.

      Did you update to the latest Cyclone Max software and firmware? If you look on the second line of the Cyclone LCD screen, it should say 7.85.

      If it doesn't please update your software.
      http://www.pemicro.com/downloads/download_file.cfm?download_id=290

      -Johnny

  • Hi Johnny

    My current version is 7.84.
    I tried to download the update from link given by you, it fails (server problem).

    Please check this.

    Regards Gautam

    • You can download it from the Cyclone Max product page under Downloads:
      http://www.pemicro.com/products/product_viewDetails.cfm?product_id=145

      • Hi Gautam,

        Did 7.84 resolve the issue?

        -Johnny

        • Hi Johny,

          Tried with v7.85.

          The problem persists, partition not taking place with this version

          Regards
          Gautam

          • Gautam,

            I just noticed that you have the RE command right before the PA. YOu should not reset the part because you will lose the algorithm code that has been downloaded into RAM.

            Please try the following instead and let me know if it works:

            CM C:\PEMicro\cyclone_max\Algorithms_Kinetis\freescale_kdx_pflash_dflash_eeprom.arp

            SS; Select my FW build file

            PA 3206; Partition

            EM; erase module

            BM; blank check module

            PM; program module

            Regards,
            Johnny
            P&E

            • Hi Johnny

              I shall check this and update you.

              Thank you

              Regards
              Gautam

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement