Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
cyclone for arm devices user manual pin out wrong,
im k. Apr 20, 2015 at 07:10 AM (07:10 hours)
Staff: Johnny N.

  • hello, im user cyclone for arm.
    today, i get cyclone and then test to my arm board in order to program src.
    but, powersupply occur overcurrent as soon as connect to my board.
    i checked user manual before using. because of short circuit i have check one more detail. i found wrong point in manual 20 page.
    Figure 3-11 is pointed PIN1 unward, it is PIN2 actually.
    this part needs to be corrected as soon as possible.




    Comments

    • Hello IM,

      Are you using the 20-pin Standard ARM connector on the right side? The position of the pins are correct but the cutout on the shroud should be facing the other direction. The shroud on the other two connectors are correct.

      Regards,
      Johnny
      P&E

      • I made the mistake of connecting ARM cable.
        cyclone run very well.
        thank you.

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement