Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Need help about SINGLE POLE, STANDARD STUD TERMINAL
Marklin P. Jul 13, 2017 at 04:06 PM (16:06 hours)
Staff: Takao Y.

  • Bullet terminal receptacle should be .312 ± .001 diameter hole not less than .250 depth. Contact Sensata for other bullet sizes. Each outer terminal is supplied with a flatwasher, tooth lockwasher and a hex nut. (for an example www.icrfq.com/part/653630-IULHK111_1REC4_37458_10.html )

    Tolerance ± .015 [.39] unless noted.
    Dimensions in brackets [ ] are millimeters.
    A Terminal protrusion dimensions are referenced from back of mounting
    panel.
    B Each screw terminal is supplied with a 10-32x.312 [7.92] or M5 x 8mm
    screw, flatwasher and external tooth lockwasher.
    C Stud terminals are supplied with a flatwasher, external tooth lockwasher
    and a 10-32 or M5 hex nut (<=70A) (<=50A for LEL),1/4-20 or M6 hex nut
    (>70A)(>50A for LEL).

    Any better idea ?

    Appreciate a lot.

    Kind Regards
    Mark




    Comments

  • Greetings,

    This forum is for discussing problems with PEmicro hardware interface or software tools. I have no idea what your post is about. Do you have any questions or concerns with any of our products?


    Takao Yamada

  • Greetings,

    Thanks for the reply. Of course, I have a concern about Debug Hardware.
    Next time I will very careful to create a topic/post.

    Kind Regards
    Mark

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement