Cart New Account Login

HomeAbout usProductsSupportForumsBlogCustomer Service

search inside this forum
Read Flash content for SPC56xx
Jürgen S. Oct 14, 2014 at 08:43 AM (08:43 hours)
Staff: Takao Y.

  • Hello,

    i want to read out the existing software of my SPC56EL70 device.
    And afterwards reprogram it with my new software.


    I have a red cyclone max "automated programmer and debug interface".
    Is this possible already or is there a software update needed for this feature ?

    Thanks in advance
    Jürgen




    Comments

  • Greetings,

    Yes, you can and you already have the software and hardware tools to do this. You can use the PROG software that comes with your cyclone max software package. You want to use the PROG for PPCNEXUS. Use this software to connect to your target board and load the same algorithm you have used in the the standalone. Use the "Upload module" command to read and save the contents of the flash.


    Takao Yamada

  • Greetings,

    Do you have any other questions or concerns?


    Takao Yamada

  • Hello again,

    i tried this with my prog software but i get the error message "Selected command is not active for this module" ???
    What can i do ?

    Thanks in advance
    Jürgen

  • Greetings,

    With the newer software for Cyclone, were you able to get past the error message?


    Takao Yamada

Add comment


   Want to comment? Please login or create a new PEMicro account.







© 2017 P&E Microcomputer Systems Inc.
Website Terms of Use and Sales Agreement